Using the production dispatch list as a primary means of clocking onto production orders or viewing outstanding work means that we make the list of production orders as relevant to the Shop Floor user as possible. An effective dispatch means:
Ideally the dispatch list should never be showing hundreds of records.
A small list focused on the actual work being done in the shop.
Focused on the task at hand:
Restrict the work centers filtered to those within the physical proximity of the scanning station.
Process focused with global filters:
Ideally only production orders ready to be released are released, and when finished they are finished. This isn’t always feasible so global filters help match the shop floor process.
Let’s work through an example. We’re going to start with a dispatch list showing too many records (636). With a few hundred (or more) a Shop Floor user isn’t going to have a workable list.
Ensure there is a “Shop Floor Client Configuration” for each:
Physical Scanning Station (with a fixed IP Address).
One for each ‘roving’ user, such as roving quality inspections, or perhaps a supervisor.
A global default / fail-safe.
On each scanning station config set:
Filter Type to be “IP” Filer to be the IP address of the scanning station. Dispatch filter to be a standard filter for the work centers involved.
In this example we’re assigning configuration CFG000002 to the scanning station 192.168.0.12
With the work centers filtered to only those that are realistically close to that physical scanning station we’ve already reduced the list down to about 160 records.
Now let’s add some process filtering with the global filters. In our fictitious shop we don’t want to show routings where the routing status is ‘Finished’. We also know that our released production orders aren’t always finished in a timely manner. We do know that the start date is never more than two weeks old, and our shop never works on orders that are more than one week ahead of schedule.
To do this we set at the global level in the Shop Floor Setup:
“Filter Start Date” to “Filter”
“Dispatch Starting Date Filter” to “-2W” ( a standard date formula)
“Prod. Routing Custom Filter” to “WHERE( Routing Status=FILTER(<>Finished))”
When the dispatch list is applied multiple filters will now be added:
The per-scanning-station / client configuration work center will be applied.
The global starting date filter will be added.
The global ending date filter will be added.
An additional custom filtering for routing status to not be finished will also be added.
Our production dispatch list has now been effectively configured to a fast and effective list that’s applicable to both the immediate scanning station as well as applying some real world filters.
We have now filtered the dispatch list down to three relevant records.
If that’s still not enough, and your install location also pre-assigns work then you can further filter by those pre-assignments with the “Dispatch Employee Filtering” to either “Current User”, or “Unassigned or Current User”.